Brakes - Esp
- Precautions
- General Description
- Schematic and Routing Diagram
- Component Location
- Diagnostic Information & Procedure
- Electronic Stability Program Check
- ESP® Warning Light Check
- ABS Warning Light Check
- EBD Warning Light (Brake Warning Light) Check
- DTC Check
- DTC Table
- DTC Clearance
- Fail-Safe Table
- Scan Tool Data
- Notes
- Scan Tool Data Definition
- Battery volt (V)
- RF Wheel speed, LF Wheel speed, RR Wheel speed and LR Wheel speed (km/h, MPH)
- G sensor (G)
- Brake switch (ON, OFF)
- Valve power driver (ON, OFF)
- Master Cyl Press (MPa)
- G sensor (lateral) (G)
- Yaw rate sensor (Deg/s)
- Steering angle Sen (°)
- Steering angle Sen (Neutral, Non neutral)
- ESP® off state (cont) (ESP® ON, ESP® OFF)
- Engine speed (RPM)
- Pump motor driver (ON, OFF)
- Inlet solenoid RF, Inlet solenoid LF, Inlet solenoid RR, Inlet solenoid LR (ON, OFF)
- Outlet solenoid RF, Outlet solenoid LF, Outlet solenoid RR, Outlet solenoid LR (ON, OFF)
- Cut solenoid No. 1, Cut solenoid No. 2 (ON, OFF)
- Suction solenoid No. 1, Suction solenoid No. 2 (ON, OFF)
- Brake Fluid Level (enough, NOT enough)
- ESP® Warning Light Does Not Come ON at Ignition Switch ON
- ESP® Warning Light Comes ON Steady
- ABS Warning Light Does Not Come ON at Ignition Switch ON
- ABS Warning Light Comes ON Steady
- EBD Warning Light (Brake Warning Light) Comes ON Steady
- Serial Data Link Circuit Check
- DTC C1016: Brake Light Switch
- DTC C1017/C1023: Lateral G Sensor/Yaw Rate Sensor
- DTC C1020/C1028: Master Cylinder Pressure Sensor Power Supply Failure/Circuit
- DTC C1021/C1022/C1025/C1026/C1031/C1032/C1035/C1036: Wheel Speed Sensor Circuit/Sensor or Encoder; (DTC C1021/C1025/C1031/C1035: Right-Front/Left-Front/Right-Rear/Left-Rear Wheel Speed Sensor Circuit); (DTC C1022/C1026/C1032/C1036: Right-Front/Left-Front/Right-Rear/Left-Rear Wheel Speed Sensor or Encoder)
- DTC C1024: Steering Angle Sensor
- DTC C1027: ESP® OFF Switch
- DTC C1033: Wheel Speed Sensor Deviation
- DTC C1034/C1039: Yaw Rate/G Sensor Assembly Power Supply Failure/Internal Failure
- DTC C1037: Steering Angle Sensor Power Supply Failure
- DTC C1038: Steering Angle Sensor Detect Rolling Counter
- DTC C1040: ESP® Continuous Operation
- DTC C1041/C1042/C1043/C1044/C1045/C1046/C1051/C1052/C1053/C1054/C1055/C1056: Inlet/Outlet/Cut/Suction Solenoid; (DTC C1041/C1045/C1051/C1055: Right-Front/Left-Front/Right-Rear/Left-Rear Inlet Solenoid); (DTC C1042/C1046/C1052/C1056: Right-Front/Left-Front/Right-Rear/Left-Rear Outlet Solenoid); (DTC C1043/C1044: Cut Solenoid No. 1/No. 2); (DTC C1053/C1054: Suction Solenoid No. 1/No. 2)
- DTC C1057: Power Supply Voltage Too High/Too Low
- DTC C1061: Pump Motor Circuit
- DTC C1063: Solenoid Valve Power Supply Driver Circuit
- DTC C1071: Control Module Internal Defect
- DTC C1075: Steering Angle Sensor Calibration
- DTC C1091: CAN Invalid Data from ECM
- DTC C1096: Yaw Rate/G Sensor Assembly Message Counter Error
- DTC U0073: Control Module Communication Bus Off
- DTC U0100: Lost Communication with ECM/PCM
- DTC U0101: Lost Communication with TCM
- DTC U0114: Lost Communication with Four-Wheel Drive Clutch Control Module
- DTC U0123: Lost Communication with Yaw Rate Sensor Module
- DTC U0126: Lost Communication with Steering Angle Sensor
- Repair Instruction
- Specification
- Special Tool and Equipment