Scan Tool Data: Notes
The parameter data below are values measured with the scan tool when the normally operating vehicle is under the following conditions. When taking measurements for comparison by using the scan tool, be sure to check that the vehicle is under the following conditions.
- Apply parking brake and block wheels.
- Ignition switch ON.
- Turn OFF air conditioning (if equipped).
- Set the wheel in straight-ahead position and hands off steering wheel.
- Turn OFF all electric loads (except ignition).
- Check that there is no DTC.
SCAN TOOL DATA
| Scan Tool Data | Standards | Condition | |
|---|---|---|---|
| Battery voltage | 10.0 - 16.0 | V Ignition switch ON | |
| RF Wheel speed | 0 km/h, 0.0 MPH | Vehicle is in stationary condition | |
| LF Wheel speed | 0 km/h, 0.0 MPH | Vehicle is in stationary condition | |
| RR Wheel speed | 0 km/h, 0.0 MPH | Vehicle is in stationary condition | |
| LR Wheel speed | 0 km/h, 0.0 MPH | Vehicle is in stationary condition | |
| Brake switch | ON | Brake pedal is depressed | |
| OFF | Brake pedal is released | ||
| Valve power driver | ON | Ignition switch ON | |
| Master Cyl Press | 0 ± 0.8 MPa | Brake pedal is released | |
| G sensor (lateral) | 0 ± 0.1 G | Vehicle is on the level | |
| Yaw rate sensor | 0 ± 4 deg/s | Vehicle is on the level | |
| Steering angle Sen | 0 ± 3° | Front wheels are in straight-ahead position | |
| Steering angle Sen | Neutral | Front wheels are in straight-ahead position | |
| ESP® off state (cont) | ESP® ON | ESP® OFF switch is OFF condition | |
| ESP® OFF | ESP® OFF switch is ON condition | ||
| Engine speed | 0 RPM | Engine at stop with ignition switch turned ON | |
| Pump motor driver | OFF | Vehicle is in stationary condition | |
| Inlet solenoid | RF | OFF | Vehicle is in stationary condition |
| LF | |||
| RR | |||
| LR | |||
| Outlet solenoid | RF | OFF | Vehicle is in stationary condition |
| LF | |||
| RR | |||
| LR | |||
| Cut solenoid | No.1 | OFF | Vehicle is in stationary condition |
| No.2 | |||
| Suction solenoid | No.1 | OFF | Vehicle is in stationary condition |
| No.2 | |||
| Brake fluid level | enough | Brake fluid level is filled | |
| NOT enough | Brake fluid level is lower than minimum level | ||