LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Keyless Start System) >> Diagnostics Information and Procedures >> DTC B1134: Remote Controller Battery Low >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSIS PROCEDURE

Step Action YES NO
1  Remote controller check 
  1. Prepare all registered remote controller.
  2. Push engine switch to change ignition mode to "ON" with remote controller carried with oneself.
  3. Check whether "KEY FOB LOW BATTERY" is shown in information display.
  4. Push engine switch to change ignition mode to "OFF".
  5. Perform Step  2) through  4) for all remote controllers.

Is "KEY FOB LOW BATTERY" shown in information display? 		 Go to Step 2. End. (Remote controller battery run down signal was detected in the past. (DTC is not cleared))
2  Remote controller battery check 
  1. Replace battery of corresponding remote controller with new one, see Replacement of Remote Controller Battery .
  2. Clear DTC, see DTC Clearance .
  3. Perform DTC CONFIRMATION PROCEDURE  and then recheck DTC.

Is DTC B1134 still detected? 		 Replace remote controller and recheck DTC. End.
scientia non olet · About LEMON Manuals