Replacement of Remote Controller Battery

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.

Remove emergency key (4).
Remove upper case (1) using a flat-end screwdriver as shown in figure.
Remove printed circuit board (2) from lower case (3).

Fig 1: Removing Upper Case Using Flat-End Screwdriver
Courtesy of SUZUKI OF AMERICA CORP.
Remove battery (2) using a flat-end screwdriver (1) as shown in figure.

Fig 2: Removing Battery Using Flat-End Screwdriver
Courtesy of SUZUKI OF AMERICA CORP.
Place battery (lithium disc-type CR 2032 or equivalent) (1) so its "-" terminal faces "-" mark of the printed circuit board (2).

Fig 3: Placing Battery
Courtesy of SUZUKI OF AMERICA CORP.
Install printed circuit board to lower case and then fit upper case securely.
NOTE: Dispose of the used battery properly according to applicable rules or regulations. Do not dispose of lithium batteries with ordinary household trash.