Input Speed Sensor Seal Replacement

Fig 1: Identifying Input Speed Sensor Seal

Courtesy of SUZUKI OF AMERICA CORP.

COMPONENT NAME REFERENCE

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE . Drain the transmission, refill when repair is completed. Refer to TRANSMISSION FLUID REPLACEMENT . Remove the left engine splash shield. Refer to ENGINE SPLASH SHIELD REPLACEMENT - LEFT SIDE . Remove the left transmission mount and bracket. Refer to TRANSMISSION MOUNT BRACKET REPLACEMENT - LEFT SIDE .
1	Input Speed Sensor Bolt M6 x 25 CAUTION: Refer to FASTENER NOTICE . Tip: Apply threadlocker GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the input speed sensor bolt. Tightening torque 9 N.m (80 lb in)
2	Input Speed Sensor (ISS) Tip: Pull the ISS out of the case cover just far enough to gain access to the ISS seal.
3	Input Speed Sensor Seal Remove the ISS seal by pulling it over the end of the ISS base. Install the new ISS Seal by gently stretching it over the ISS base. Overstretching the seal will cause it to not seal properly. The seal is coated with a dry lubricant. If the coating is missing, lubricate the seal with automatic transmission fluid prior to installation.