Driver Air Bag (Inflator) Module Removal and Installation: Installation

WARNING: This page is about a different car, the 2006 Suzuki XL-7. However, it is still accessible from the selected car via links, so may be relevant.

Reference: DRIVER AIR BAG (INFLATOR) MODULE INSPECTION

Connect horn connector (4) securely.
Connect driver air bag (inflator) module connectors (1) (orange) and (2) (black) to driver air bag (inflator) module (3) securely as shown in the figure.
1. Connect connectors.
2. Lock connectors with lock button.
  
  Fig 1: Identifying Driver Air Bag (Inflator) Module Connectors, Driver Air Bag Module & Horn Connector
  Courtesy of SUZUKI OF AMERICA CORP.
Install driver air bag (inflator) module (1) to steering wheel (2), taking care so that no part of wire harness is caught between them.
Make sure that clearance between module (1) and steering wheel (2) is uniform all the way.
Tighten driver air bag (inflator) module mounting bolt (left side) (3) to specified torque first and then driver air bag (inflator) module mounting bolt (right side) (4) to specified torque.
Tightening torque

Driver air bag (inflator) module mounting bolt a: 9 N.m (0.9 kg-m, 6.5 lb-ft)

Fig 2: Identifying Driver Air Bag (Inflator) Module, Steering Wheel & Mounting Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Connect negative cable at battery.
Enable air bag system. Refer to ENABLING AIR BAG SYSTEM .