Vehicles with Start/Stop System
WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Vehicles with the Start/Stop System have a special battery due to the increased load on the cycles.
- When replacing the battery, note the correct replacement part identification.
- Batteries for vehicles with the Start/Stop System have "AGM" (Absorbent Glass Mat) or "EFB" (Enhanced Flooded Battery) marked on them.
Continuation for all vehicles
-- Insert the battery into the battery tray -1- so that the battery clamping strip touches the rear and side stops -arrows-.
- It must not be possible to slide the battery rearward or to the side.
-- Install the bracket -1-.
- The tab -arrow- on the bracket -1- must engage into the opening on the battery clamping strip.
-- Tighten the bolt -2- for the bracket -1-.
-- Check the battery for secure fit.
When the ignition and electrical equipment are switched off, connect the battery in the following sequence:
-- Install the battery positive cable terminal clamp -3- on the battery positive terminal "+".
-- Tighten the nut -4-.
-- Connect the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .
CAUTION:
If the battery is replaced, the Battery Monitoring Control Module -J367- must be adapted. Refer to Battery Monitoring Control Module -J367-, ADAPTING .
Tightening Specifications