Overview - Rear Motor
WARNING: This page is about a different car, the 2023 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
- Connector
- High voltage
- Wiring Guide
- Bolt
- Quantity: 6
- 8 Nm
- O-Ring
- Clip
- Coolant Hose
- Clip
- Clamp
- Bolt
- Quantity: 2
- Replace after removing
- 8 Nm +90°
- O-Ring
- Replace after removing
- Connection
- Three-Phase Current Drive -VX54-
- With Electric Drive Power and Control Electronics -JX1-
- Refer to ELECTRIC DRIVE POWER AND CONTROL ELECTRONICS, REMOVING AND INSTALLING, AWD .
- Refer to Rear Motor, Removing .
- Refer to Rear Motor, Installing .
- Coolant Pipe
- To remove, remove the high-voltage battery. Refer to High-Voltage Battery Unit .
- O-Ring
- Breather Valve
- Special lubricant for the seal. Refer to the appropriate Electronic Parts Information.
- Replace after removing
- Bolt
- Quantity: 2
- Replace after removing
- 130 Nm +180°
- Bolt
- Quantity: 3
- Replace after removing
- 70 Nm +180°
- Motor Support
- Bolt
- Replace after removing
- 130 Nm +180°
- Temperature Sensor -G18-
- O-Ring
- Replace after removing
- Coolant Hose
- Bracket
- Attachment point for the potential equalization cable
- Nut
- 8 Nm
- O-Ring
- Bleeder Line
- Bolt
- 8 Nm
- Connector