Overview - Ignition System
WARNING: This page is about a different car, the 2023 Volkswagen Atlas Cross Sport, 2022 Volkswagen Atlas Cross Sport, 2021 Volkswagen Atlas Cross Sport, and 2020 Volkswagen Atlas Cross Sport. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Engine Speed Sensor -G28- is located on the cylinder block. Refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
- Ignition Coils with Power Output Stage -N70, N127, N291, N292, N323, N324-
- Removing and installing. Refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .
- Ignition sequence. Refer to CYLINDER NUMBERING .
- Connector
- Black
- Use the Elbow Assembly Tool :T10118 to remove
- Bracket
- For the Knock Sensor 1 -G61- connector
- Bolt
- 20 Nm
- Connector
- Black, 3-pin
- Gold plated sensor contacts and connector contacts
- Knock Sensor 1 -G61-
- Component location: cylinder block exhaust side
- Bolt
- 20 Nm
- The tightening specifications affect function of the knock sensor
- Exhaust Camshaft Adjuster
- Identification: 32A
- With sensor wheel for the Camshaft Position Sensor 2 -G163-
- Removing and installing. Refer to CAMSHAFT ADJUSTER, REMOVING AND INSTALLING .
- Cover
- Connector
- Black, 3-pin
- Gold plated sensor contacts and connector contacts
- Mark the connector before disconnecting
- Bolt
- 10 Nm
- Camshaft Position Sensor 2 -G163-
- For the exhaust camshaft
- Gold plated sensor contacts and connector contacts
- O-Ring
- Always replace
- Camshaft Position Sensor -G40-
- For the intake camshaft
- Gold plated sensor contacts and connector contacts
- Knock Sensor 2 -G66-
- Component location: cylinder block intake side
- Gold plated sensor contacts and connector contacts
- Connector
- Black, 2-pin
- Gold plated sensor contacts and connector contacts
- Intake Camshaft Adjuster
- Identification: 24E
- With sensor wheel for the Camshaft Position Sensor -G40-
- Removing and installing. Refer to CAMSHAFT ADJUSTER, REMOVING AND INSTALLING .
- Spark Plug
- 18 Nm
- Remove and install with the Spark Plug Removal Tool :3122B
- Timing Chain Cover
- For the camshaft adjustment
- Removing and installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .