Engine Speed Sensor -G28-, Removing And Installing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas Cross Sport, 2022 Volkswagen Atlas Cross Sport, 2021 Volkswagen Atlas Cross Sport, and 2020 Volkswagen Atlas Cross Sport. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the connector -1- from the Engine Speed Sensor -G28-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the screw -2- and remove the engine speed sensor -3- by gently rotating.

Installing:

Install in reverse order of removal while noting the following:

-- Replace the seals and coat them lightly with clean engine oil.

-- Do not tilt the engine speed sensor -3- when installing.

-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

Tightening Specification:

Component	Tightening Specification
Speed sensor bolt	8 Nm