Common Specs & Procedures
SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | CAPACITIES | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front | 70 Nm +90° | ||
| Rear | 180 Nm +180° | ||
| Battery | 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL | ||
| Brakes | |||
| Bleeding Sequence | BRAKE SYSTEM, BLEEDING | ||
| Disc Brakes | FRONT BRAKES | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS
Hydraulic Components FASTENER TIGHTENING SPECIFICATIONS Mechanical Components |
||
| Charging | |||
| Generator | N/A | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | RIBBED BELT | ||
| Belt Routing | See fig. 21 under RIBBED BELT | ||
| Engine Cooling | |||
| General Service Specifications | Refer to the approrpiate FLUID CAPACITY TABLES information. | ||
| Radiator Cap Pressure | 1.4 to 1.6 bar | ||
| Thermostat R & I | COOLANT THERMOSTAT HOUSING WITH THERMOSTAT | ||
| Water Pump R & I | COOLANT PUMP | ||
| Engine Mechanical | |||
| Compression | COMPRESSION PRESSURE, CHECKING | ||
| Oil Pressure | Start the engine and increase the engine speed. The LED must come on at 1.2 to 1.6 bar pressure. Increase the engine speed further. At 2000 RPM/min and an oil temperature of 80 °C (176 °F), the oil pressure must be between 2.7 and 4.5 bar. At higher engine speeds the oil pressure must not exceed 7.0 bar |
||
| Overhaul | 10 ENGINE ASSEMBLY | ||
| Torque | ENGINE, INSTALLING | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. | ||
| Flywheel/Flex Plate Torque | 60 Nm + an additional 90° (1/4) turn | ||
| Fuel System | |||
| Pressure Specification | The fuel injection system is separated into a high pressure side, where the pressure is a maximum of approximately 150 bar and a low pressure side, where the pressure is approximately 6 bar. | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE SENSOR, CHECKING | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Spark Plug | TEST DATA AND SPARK PLUGS | ||
| Starting | |||
| Starter | N/A | ||
| Torque | N/A | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFIED VALUES | ||
| Torque | |||
| Front | FASTENER TIGHTENING SPECIFICATIONS | ||
| Rear | FASTENER TIGHTENING SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 120 Nm | ||