Multifunction Transmission Range Switch -F125- : Installing
Install in the reverse order of removal. Note the following:
-- Install the switch -4- to the selector shaft -6- .
-- Install the bolts -5- for the Multifunction Transmission Range Switch -F125- hand tight.
-- Bend back the hooks on the lock washer -2- .
-- Install the washers -2 and 3- on the selector shaft -6- .
-- Install the washer -2- with the hooks facing up.
-- Install the washer -2- with the long narrow guide into the long narrow depressions in the selector shaft -6- .
-- Tighten the nut -1- to 7 Nm.
-- Tighten the nut -1- and secure it by bending the hook on the washer -2- upward.
-- Replace the lock washer is a hook breaks off.
-- Install the lever -3- to the selector shaft -4- .
-- Move the selector lever -3- into the "P" position. This means, push the selector lever -3- opposite the drive direction until it stops.
-- Move the lever -3- into the "N" position. Push the lever -3- two position forward in the direction of travel.
-- Mount the spring washer -2- and the nut -1- on the selector shaft -4- .
-- Adjust the Multifunction Transmission Range Switch -F125- . Refer to Adjusting Procedure .
-- Tighten the nut -1- to 13 Nm.
-- Check the selector mechanism. Refer to SELECTOR MECHANISM, CHECKING .
-- If removed, install the air filer housing.