Adjusting Procedure

-- Move the selector lever into the "N" position.

-- Do not bend the selector lever cable.

Adjustment Prerequisites

The selector lever cable is disconnected at the selector shaft lever
The selector shaft is in the "N" position.
The bolts for the Multifunction Transmission Range Switch -F125- have been loosened.
The selector shaft lever is removed.

Alignment

-- Place the setting gauge T10173 on the selector shaft -2- and turn the Multifunction Transmission Range Switch -F125- -1- until the setting gauge T10173 locks into the tab on the Multifunction Transmission Range Switch -F125- connector.

Fig 1: Adjustment Tool Attached Onto Shift Rod

NOTE:

If the tab on the connector does not lock into the groove in the setting gauge T10173, then the transmission is no longer in "N" . In this case, shift the transmission into "N" using the setting gauge T10173.

-- Tighten the setting gauge T10173 on the selector shaft -2- with the bolt -3- .

-- Tighten the bolts -arrows- to 6 Nm.

-- Remove the setting gauge T10173.

-- Further installation is performed in the reverse of removal. Refer to Installing .