MULTIFUNCTION Transmission Range Switch, Adjusting

Special tools and workshop equipment required 

• Setting Gauge -T10173-

-- Move the selector lever into the "N" position.

-- Do not bend the selector lever cable.

Prerequisites: 

• The selector lever cable is disconnected from selector shaft lever
• The selector shaft is in the "N" position.
• The bolts for the multifunction transmission range switch -F125- have been loosened.
• The selector shaft lever is removed.

Procedure 

-- Install the setting gauge -T10173- on the selector shaft -2- and turn the multifunction switch -1- just until the setting gauge locks onto the tab on the multifunction switch connector.

Fig 1: Identifying Adjustment Tool Attached Onto Shift Rod

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Use the bolt -3- to secure the setting gauge to the selector shaft -2-.

-- Tighten the multifunction switch bolts -arrows- to 6 Nm.

-- Remove the setting gauge.

-- Further installation is performed in the reverse sequence. Refer to Installing .