Control module for multi-function steering wheel, removing and installing: Removing:

• Remove drivers side airbag unit, → 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS

NOTE:

• When performing work on removed airbag unit, do not position directly in field of view.
• Before starting repair work on removed airbag unit, electrostatically discharge yourself. This is accomplished by, for example, touching grounded metal like water pipes, heating pipes or metal carriers

• Remove drivers airbag attachment panel, → 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS
• Lay aside removed airbag unit on soft surface with top side facing down (this applies only to following repair work).

Fig 1: Identifying Harness Connectors

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Disengage and disconnect harness connectors - arrows  -.

Fig 2: Identifying Mounting Bolts For Signal Horn Operation

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove 4 mounting bolts from signal horn operation - arrows  -.

Fig 3: Identifying Harness Connector Of Airbag Unit

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Before removing bracket for signal horn operation, disengage harness connector of airbag unit and disconnect - arrow  -.

Fig 4: Identifying Harness Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Disengage harness connector - arrow  - and disconnect it.

Fig 5: Identifying Bolt On Rear Side Of Control Module

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove bolt on rear side of control module - arrow  - and remove control module.