Display group 4 -basic functions-

Display group 4 -basic functions-
Engine running at idle
Read Measuring Value Block 4			→	← Indicated on display:
xxxx/min	xx.xxx V	xxx.x ° C	xxx.x ° C
1	2	3	4	← Display fields	Specified value	Evaluation
				Intake Air Temperature (IAT)	-48 to 110 ° C	Refer to Evaluation display group 4, display field 4 - intake air temperature
			Coolant temperature		80 to 110 ° C	Refer to Evaluation display group 4, display field 3 - coolant temperature
		Voltage supply for Engine Control Module (ECM)			12.0 to 15.0 V	Refer to Evaluation display group 4, display field 2 - control module voltage supply
	Engine speed (idle speed) Manual transmission Automatic transmission				700 to 820 RPM 640 to 760 RPM	Refer to Evaluation display group 1, display field 1 - engine speed (idle speed)

Note for display field 3:

When a DTC relating to the Engine Coolant Temperature (ECT) sensor -G62- is stored in DTC memory, the Engine Control Module (ECM) starts using the intake air temperature as a replacement value when starting the engine (starting temperature replacement value). After this, the temperature rises according to a mapping specification stored in the control module. For a warm engine, a fixed replacement value is used after a certain period of time. This fixed replacement value is also dependent on the intake air temperature.

Note for display field 4:

The entire temperature range is indicated as a specified value. The indicated value must be above the ambient air temperature.