LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Steering Wheel And Column) >> Repair Instructions >> Steering Wheel Removal and Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Wheel Removal and Installation: Installation

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Step 1) and  2) are prerequisite for installation of steering wheel. If steering wheel has been installed without these steps, contact coil cable assembly will break when steering wheel is turned.
  1. Conduct centering of contact coil cable assembly, see CENTERING OF CONTACT COIL CABLE ASSEMBLY .
  2. Align steering shaft with matchmark (1) of steering shaft and steering wheel and install steering wheel.
  3. Tighten steering wheel nut to specified torque.

    Tightening torque 

    Steering wheel nut (a): 33 N.m (3.4 kg-m, 24.5 lbf-ft) 

    Fig 1: Identifying Steering Shaft With Matchmark
    G06526640Courtesy of SUZUKI OF AMERICA CORP.
  4. Connect steering switch connector.
  5. Install driver air bag (inflator) module to steering wheel, see DRIVER AIR BAG (INFLATOR) MODULE INSPECTION .
  6. Connect negative (-) cable at battery.
  7. Enable air bag system, see ENABLING AIR BAG SYSTEM .
scientia non olet · About LEMON Manuals