LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Cruise Control System) >> Diagnostic Information and Procedures >> DTC P0575: Cruise Control Input Circuit >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSIS PROCEDURE

Step Action YES NO
1  Parameter check 
  1. Connect SUZUKI scan tool to DLC with ignition mode of keyless push start system in "OFF".
  2. Push engine switch to change ignition mode to "ON".
  3. Check "Cruise CANCEL Switch", "Cruise RES/ACC Switch", "Cruise SET/COAST Switch" and "Cruise ON/OFF Switch" displayed on SUZUKI scan tool.

Are they in good condition? 		 Intermittent trouble. Go to Step 2.
2  Cruise control switch circuit check 
  1. Confirm that ignition mode of keyless push start system is "OFF".
  2. Disconnect "C01", "E01" and "G165" connectors.
  3. Check for proper terminal connection to "C01", "E01" and "G165" connectors.
  4. If connections are OK, check the following points.
    • Resistance of "A1" and "A2" circuits: less than 3 Ω
    • Resistance between "A1" circuit and ground: infinity
    • Resistance between "A1" circuit terminal and other terminals at "G165" connector: infinity
    • Resistance between "A2" circuit terminal and other terminals at "G165" connector: infinity
    • Voltage of "A1" and "A2" circuits: 0 - 1 V (with ignition mode of keyless push start system in "ON")

Are they in good condition? 		 Go to Step 3. Repair or replace defective wire harness.
3  Cruise control switch check 
  1. Check cruise control switch, see Cruise Control Switch Inspection 

Is it in good condition? 		 Replace ECM and recheck DTC. Replace cruise control switch.
scientia non olet · About LEMON Manuals