Gear Shift Lever Front Case Assembly Disassembly and Reassembly: Reassembly

Reference: GEAR SHIFT LEVER FRONT CASE ASSEMBLY INSPECTION 

1. Install new gear shift shaft oil seal (1) to gear shift lever front case using special tool.

   Special Tool 

   (A): 09923-46020 

   Fig 1: Installing Gear Shift Shaft Oil Seal To Gear Shift Lever Front Case Using Special Tool

   Courtesy of SUZUKI OF AMERICA CORP.
2. Assemble components parts referring to GEAR SHIFT LEVER FRONT CASE ASSEMBLY COMPONENTS .
3. Set new gear shift arm inner pin (1) and outer pin (2) facing each gap ("a", "b") as shown in figure.

   Drive gear shift arm pins by using special tool, till pin protrusion becomes specified length "c".

   Special Tool 

   (A): 09925-78210 

   Gear shift arm pin protrusion "c": 0.5-1.5 mm (0.020-0.059 in.) 

   Fig 2: Installing Gear Shift Arm Pin Using Special Tool

   Courtesy of SUZUKI OF AMERICA CORP.