Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Master Cylinder Body Reservoir Seals

Courtesy of SUZUKI OF AMERICA CORP.

Install the reservoir seals to the master cylinder body.
Install the reservoir to the master cylinder body by pushing the reservoir bayonets straight down into the seals in the master cylinder body.
Install NEW reservoir attachment pins. Ensure that the attachment pins are fully and firmly seated.

Fig 2: Identifying Brake Fluid Level Sensor
Courtesy of SUZUKI OF AMERICA CORP.
Install the brake fluid level sensor. Refer to INSTALLATION PROCEDURE .

Fig 3: Identifying Brake Fluid Level Sensor Electrical Connector
Courtesy of SUZUKI OF AMERICA CORP.
Connect the brake fluid level sensor electrical connector.
Install the underhood electrical center. Refer to UNDERHOOD ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT .
Fill the master cylinder reservoir. Refer to MASTER CYLINDER RESERVOIR FILLING .
Bleed the brake system. Refer to HYDRAULIC BRAKE SYSTEM BLEEDING (PRESSURE) and HYDRAULIC BRAKE SYSTEM BLEEDING (MANUAL) .