Tightening Torque Specifications

CAUTION: For fastener with * (asterisk) below, be sure to tighten it according to specified procedure in "Repair Instructions".

TIGHTENING TORQUE SPECIFICATIONS

Fastening part	Tightening torque
Fastening part	N.m	kgf-m	lbf-ft
Cylinder block heater bolt	11	1.1	8.5
Cylinder head cover bolt*	3.0 N.m → 5.0 N.m → 7.5 N.m (0.31 kgf-m → 0.51 kgf-m → 0.76 kgf-m, 2.5 lbf-ft → 4.0 lbf-ft → 5.5 lbf-ft)
CMP actuator bolt	60	6.1	44.5
Camshaft housing bolt*	11	1.1	8.5
Exhaust camshaft timing sprocket bolt	60	6.1	44.5
Timing chain cover plug	27	2.8	20.0
Engine harness ground bolt (M6)	11	1.1	8.5
Engine harness ground bolt (M8)	25	2.5	18.5
Engine rear mounting member bolt	55	5.6	40.5
Battery ground terminal bolt	25	2.5	18.5
Timing chain cover bolt*	25	2.5	18.5
Crankshaft pulley bolt	150	15.3	111.0
OCV bolt	11	1.1	8.5
Flywheel bolt	70	7.1	52.0
Drive plate bolt	70	7.1	52.0
Timing chain guide bolt	9	0.92	7.0
Timing chain tensioner bolt	25	2.5	18.5
Timing chain tensioner adjuster bolt	11	1.1	8.5
Cylinder head bolt *	20 N.m → 40 N.m → +60° → +80° (2.0 kgf-m → 4.1 kgf-m → +60° → +80°, 15.0 lbf-ft → 29.5 lbf-ft → +60° → +80°)
Venturi plug	3.5	0.36	2.5
Connecting rod bolt*	15 N.m → +45° → +45° (1.5 kgf-m → +45° → +45°, 11.0 lbf-ft → +45° → +45°
Sensor plate screw	11	1.1	8.5
Crank case bolt No. 1*	50 N.m → 0 N.m → 20 N.m → 35 N.m → 40° → 40° (5.1 kgf-m → 0 kgf-m → 2.0 kgf-m → 3.6 kgf-m → 40° → 40°, 37.0 lbf-ft → 0 lbf-ft → 15.0 lbf-ft → 26.0 lbf-ft → 40° → 40°)
Crank case bolt No. 2*	25	2.5	18.5
Oil pump chain adjuster bolt	11	1.1	8.5
Engine front mounting bracket bolt	55	5.6	40.5

Reference:

For the tightening torque of fastener not specified in this information, refer to FASTENER INFORMATION .