LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC B1453 >> Conditions for Clearing the DTC
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Conditions for Clearing the DTC

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.

Step Action Values Yes No
CAUTION: Refer to Sensing and Diagnostic Module Handling Caution .
CAUTION: Refer to Sensing and Diagnostic Module Voltage after Ignition is Turned Off Caution .
Schematic Reference:  SIR Schematics (Notchback)   or  SIR Schematics (Except North American (Hatchback))   or  SIR Schematics (North American (Hatchback))  Connector End View Reference:  SIR Connector End Views (Notchback)   or  SIR Connector End Views (Hatchback)  
1 Did you perform a Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Confirm the ignition switch is OFF.
  2. Wait one minute for sensing and diagnostic module (SDM) to discharge.
  3. Visually inspect the wiring and connectors between the SDM and the cluster.
Is the wiring and connector OK?		 - Go to Step 4  Go to Step 3 
3 Repair the wiring and connector between the SDM and the cluster.
Is the repair complete?		 - Go to Step 9  -
4
  1. Confirm the ignition switch is OFF.
  2. Wait one minute for SDM to discharge.
  3. Disconnect the cluster connector.
  4. Disconnect the SDM connector.
  5. On North America vehicles, measure the resistance between terminal 57 of SDM and terminal B3 of the cluster.
  6. On all except North America Vehicles, measure the resistance between terminal 57 of SDM and terminal B14 of the cluster.
Is the resistance as specified?		 0 Ω Go to Step 5  Go to Step 8 
5 Measure the resistance between terminal 57 of SDM and ground.
Is the as specified?		 ∞ Go to Step 6  Go to Step 8 
6
  1. Replace the cluster. Refer to Inflatable Restraint Instrument Panel Module Disable Switch Replacement .
  2. Reconnect all SIR components.
  3. Verify that all components, connectors and connector position assurances (CPAs) are properly mounted.
  4. Use the scan tool in order to clear the DTCs.
  5. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text.
Does the DTC reset?		 10.6 V Go to Step 7  Go to Step 9 
7 Replace the SDM. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement .
Is the replacement complete?		   Go to Step 9  -
8 Replace the airbag wiring.
Is the replacement complete?		 - Go to Step 9  -
9
  1. Reconnect all SIR components.
  2. Verify that all components, connectors and connector position assurances (CPAs) are properly mounted.
  3. Use the scan tool in order to clear the DTCs.
  4. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text.
Does the DTC reset?		 - Go to Step 2  -
scientia non olet · About LEMON Manuals