LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC B1405 >> Conditions for Clearing the DTC
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Conditions for Clearing the DTC

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.

Step Action Values Yes No
CAUTION: Refer to Sensing and Diagnostic Module Handling Caution .
CAUTION: Refer to Sensing and Diagnostic Module Voltage after Ignition is Turned Off Caution .
Schematic Reference:  SIR Schematics (Notchback)   or  SIR Schematics (Except North American (Hatchback))   or  SIR Schematics (North American (Hatchback))  Connector End View Reference:  SIR Connector End Views (Notchback)   or  SIR Connector End Views (Hatchback)  
1 Did you perform a Diagnostic System Check - Vehicle?   Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Confirm the ignition switch is OFF.
  2. Wait for 1 minute for the sensing and diagnostic module (SDM) charger to be discharged.
Has the SDM discharged?		 - Go to Step 3  -
3 Visually inspect for any damage on the passenger side impact sensor wiring and the connector.
Are the passenger side impact sensor wiring and connector OK?		 - Go to Step 5  Go to Step 4 
4 Connect the connector or repair the damage.
Did you complete the action?		 - Go to Step 10  -
5
  1. Disconnect the SDM connector.
  2. Disconnect the passenger side impact sensor connector.
  3. Measure the resistance between terminal 68, 69 of the SDM connector and terminal 1, 2 of the passenger side impact sensor harness connector respectively.
Is the resistance equal to the specified value?		 0 Ω Go to Step 6  Go to Step 9 
6
  1. Disconnect the SDM connector.
  2. Disconnect the passenger side impact sensor connector.
  3. Measure the resistance between the high, low wiring of the passenger side impact sensor harness connector and battery positive.
Is the resistance equal to the specified value?		 ∞ Go to Step 7  Go to Step 9 
7
  1. Replace the passenger side impact sensor. Refer to Inflatable Restraint Side Impact Sensor Replacement .
  2. Confirm the ignition switch is ON.
  3. Use the scan tool in order to clear the DTCs.
  4. Perform the Diagnostic System Check - Vehicle .
Is the DTC removed?		 - Go to Step 10  Go to Step 8 
8 Replace the SDM. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement .
Is the replacement complete?		 - Go to Step 10  -
9 Replace the air bag wiring.
Is the replacement complete?		 - Go to Step 10  -
10
  1. Reconnect all SIR components.
  2. Verify that all components, connectors and connector position assurances (CPAs) are properly mounted.
  3. Use the scan tool in order to clear the DTCs.
  4. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text.
Does the DTC reset?		   Go to Step 2  System OK
scientia non olet · About LEMON Manuals