LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC B1367 >> Conditions for Clearing the DTC
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Conditions for Clearing the DTC

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.

Step Action Values Yes No
CAUTION: Refer to Sensing and Diagnostic Module Handling Caution .
CAUTION: Refer to Sensing and Diagnostic Module Voltage after Ignition is Turned Off Caution .
Schematic Reference:  SIR Schematics (Notchback)   or  SIR Schematics (Except North American (Hatchback))   or  SIR Schematics (North American (Hatchback))  Connector End View Reference:  SIR Connector End Views (Notchback)   or  SIR Connector End Views (Hatchback)  
1 Did you perform a Diagnostic System Check - Vehicle?   Go to Step 2  Go to Diagnostic System Check - Vehicle
2 Visually inspect the connector and the wiring of the passenger belt pretensioner.
Is the wiring damaged?		 - Go to Step 3  Go to Step 4 
3
  1. Confirm the ignition switch is OFF.
  2. Disconnect the connector of the passenger belt pretensioner.
  3. Disconnect the connector of the sensing and diagnostic module (SDM) wiring.
  4. Measure the resistance between the terminal 35, 36 of the SDM and terminal 1, 2 of the passenger belt pretensioner.
Is the resistance equal to the specified value?		 0 Ω Go to Step 4  Go to Step 6 
4
  1. Replace the SDM. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement .
  2. Confirm the ignition switch is ON.
  3. Erase the DTC using the scan tool.
  4. Perform the Diagnostic System Check - Vehicle .
Is the DTC removed?		 - Go to Step 7  Go to Step 5 
5 Replace the passenger belt pretensioner. Refer to Front Seat Belt Replacement .
Is the replacement complete?		 - Go to Step 7  -
6 Replace the air bag wiring.
Is the replacement complete?		 - Go to Step 7  -
7
  1. Reconnect all SIR components.
  2. Verify that all components, connectors and connector position assurances (CPAs) are properly mounted.
  3. Use the scan tool in order to clear the DTCs.
  4. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text.
Does the DTC reset?		   Go to Step 2  System OK
scientia non olet · About LEMON Manuals