LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC B1102 >> Conditions for Clearing the DTC
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Conditions for Clearing the DTC

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.

Step Action Values Yes No
CAUTION: Refer to Sensing and Diagnostic Module Handling Caution .
CAUTION: Refer to Sensing and Diagnostic Module Voltage after Ignition is Turned Off Caution .
Schematic Reference:  SIR Schematics (Notchback)   or  SIR Schematics (Except North American (Hatchback))   or  SIR Schematics (North American (Hatchback))  Connector End View Reference:  SIR Connector End Views (Notchback)   or  SIR Connector End Views (Hatchback)  
1 Did you perform a Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle
2 Inspect fuse F1.
Is the fuse blown?		 - Go to Step 3  Go to Step 4 
3 Replace fuse F1.
Is the replacement complete?		 - Go to Step 11  -
4
  1. Confirm the ignition switch is ON.
  2. Measure the voltage from fuse F1.
Is the voltage less than the specified value?		 10.6 V Go to Step 5  Go to Step 6 
5 Repair the power supply and the wiring to fuse F1.
Is the repair complete?		 - Go to Step 11  -
6
  1. Confirm the ignition switch is OFF.
  2. Disconnect the connector of the steering wheel module coil.
  3. Disconnect the connector of the I/P module.
  4. Disconnect the connector of the sensing and diagnostic module (SDM).
  5. Confirm the ignition switch is ON.
  6. Measure the voltage between terminal 26 of the SDM connector and the ground.
Is the voltage less than the specified value?		 10.6 V Go to Step 7  Go to Step 9 
7
  1. Disconnect the C216.
  2. Confirm the ignition switch is ON.
  3. Measure the voltage from terminal 7 of C216.
Is the voltage less than the specified value?		 10.6 V Go to Step 8  Go to Step 10 
8 Repair the wire between the fuse F1 and the terminal 7 of connector C216.
Is the repair complete?		 - Go to Step 11  -
9 Replace the SDM. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement .
Is the replacement complete?		 - Go to Step 11  -
10 Repair the wire between the SDM terminal 26 and the terminal 7 of connector C214.
Is the replacement complete?		 - Go to Step 11  -
11
  1. Reconnect all SIR components.
  2. Verify that all components, connectors and connector position assurances (CPAs) are properly mounted.
  3. Use the scan tool in order to clear the DTCs.
  4. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text.
Does the DTC reset?		   Go to Step 2  System OK
scientia non olet · About LEMON Manuals