Conditions for Clearing the DTC

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.

Step	Action	Yes	No
CAUTION: Refer to Sensing and Diagnostic Module Handling Caution . CAUTION: Refer to Sensing and Diagnostic Module Voltage after Ignition is Turned Off Caution . Schematic Reference: SIR Schematics (Notchback) or SIR Schematics (Except North American (Hatchback)) or SIR Schematics (North American (Hatchback)) Connector End View Reference: SIR Connector End Views (Notchback) or SIR Connector End Views (Hatchback)
1	Did you perform a Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Inspect the vehicle charging system including the alternator. Is the charging system OK?	Go to Step 4	Go to Step 3
3	Repair the charging system. Is the repair complete?	Go to Step 5	-
4	Disconnect the negative battery cable. Replace the sensing and diagnostic module (SDM). Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement . Is the repair complete?	Go to Step 5	-
5	Reconnect all SIR components. Verify that all components, connectors and connector position assurances (CPAs) are properly mounted. Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text. Does the DTC reset?	Go to Step 2	System OK