DTC Troubleshooting

WARNING: This page is about a different variant/trim than selected.

DTC TROUBLESHOOTING TABLE

Step	Action	YES	NO
1	Was "A/T System Check" performed?	Go to Step 2.	Go to A/T SYSTEM CHECK .
2	Check output shaft speed sensor circuit Disconnect TCM connectors with ignition switch turned OFF. Check for proper connection to output shaft speed sensor at "C07-5" and "C07-14" terminals. If OK, check resistance of sensor circuit. Resistance of input shaft speed sensor circuit Between terminals "C07-5" and "C07-14" of disconnected harness side TCM connector: 344 - 516 Ω at 20 °C (68 °F) Between terminal "C07-5"/"C07-14" of disconnected harness side TCM connector and ground: No continuity Are they in good condition?	Go to Step 4.	Go to Step 3.
3	Check output shaft speed sensor Check output shaft speed sensor for resistance by referring to OUTPUT SHAFT SPEED SENSOR INSPECTION . Is it in good condition?	"BLK" or "WHT" wire open or short.	Replace output shaft speed sensor.
4	Check visually output shaft speed sensor and sensor rotor using mirror for the following No damage No foreign material attached Correct installation Courtesy of SUZUKI OF AMERICA CORP. Are they in good condition?	Intermittent trouble or faulty TCM. Check for intermittent by referring to INTERMITTENT AND POOR CONNECTION INSPECTION . If OK, substitute a known-good TCM and recheck.	Clean, repair or replace.