Brake Pedal Installation

WARNING: This page is about a different car, the 2006 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.

Install a new pedal cover.

Fig 1: Identifying Pedal Cover
Courtesy of SUZUKI OF AMERICA CORP.
Coat the pedal shaft with grease.
Position the brake pedal on the pedal-to-dash panel bracket and the pedal bolt.
Place the hex nut and the spring on the pedal bolt.
Tighten:

Tighten the brake pedal-to-pedal bracket hex nut to 18 N.m (13 lb-ft).
Install the pushrod clevis to the pedal with the bolt and the spring retaining clip.

Fig 2: Identifying Retaining Clip
Courtesy of SUZUKI OF AMERICA CORP.
Connect the stoplamp switch and connector assembly to the pedal bracket. Refer to Stoplamp Switch Installation .
Install the knee bolster. Refer to DRIVER'S SIDE KNEE BOLSTER INSTALLATION .
Install the trim panel with the screws.
Tighten:

Tighten the trim panel screws to 3 N.m (27 lb-in.).

Fig 3: Removing/Installing Trim Panel And Screw
Courtesy of SUZUKI OF AMERICA CORP.