Park/Neutral Start Switch Removal and Installation: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required:

DW260-050 Park/Neutral Switch Installer

Install the park/neutral start switch.
Tighten:

Tighten the park/neutral start switch bolts to 10 N.m (89 lb-in).
Adjust the park/neutral switch using the Park/Neutral switch installer DW260-050.

Fig 1: Identifying Park/Neutral Switch Installer DW260-050
Courtesy of SUZUKI OF AMERICA CORP.
Install the shift lever and the shift lever nut.
Tighten:

Tighten the shift lever nut to 10 N.m (89 lb-in).

Fig 2: Identifying Shift Lever Nut
Courtesy of SUZUKI OF AMERICA CORP.
Connect the shift control cable and the retaining clip.
Connect the park/neutral position switch electrical connector.
Connect the negative battery cable.

Fig 3: Identifying Shift Control Cable And Retaining Clip
Courtesy of SUZUKI OF AMERICA CORP.