Fluid Level Set after Service
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
- Add transaxle fluid through the fill cap hole prior to adjusting the fluid level. The amount of fluid to add should be based on the type of service done.
Adjustment Notice
- Use ESSO LT 71141 or TOTAL ATF H50235 transaxle fluid only.
- Oil pan removed: 4 L (4.2 qt)
- Torque converter removed: 2 L (2.1 qt)
- Complete overhaul: 6.9 ± 0.2 L (7.3 ± 0.2 qt)
- Drain plug removed: 4 L (4.2 qt)
- Check the transaxle fluid level. Refer to Transaxle Fluid Level Checking Procedure .
- Add additional fluid through the fill cap hole in 0.5 L (0.5 qt) increments until the fluid comes out through the plug hole.
- Allow the fluid to finish draining out through the plug hole, then install the fluid level plug.
- When the fluid level setting procedure is completed, wipe any fluid from the transaxle case with a rag or shop towel. Also, check that the fluid fill cap and the vent tube are properly installed.