Control Valve Body Assembly Removal and Installation: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.

Tilt the valve body.
Install the output speed sensor mounting bolt.
Tighten:

Tighten the output speed sensor mounting bolt to 6 N.m (53 lb-in).

Fig 1: Identifying Automatic Transaxle Output Speed Sensor Mounting Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Install the control valve body and the bolts.
Tighten:

Tighten the valve body mounting bolts to 8 N.m (71 lb-in).
Install the input speed sensor mounting bolt.
Tighten:

Tighten the input speed sensor mounting bolt to 8 N.m (71 lb-in).
Install the oil pan and oil pan gasket. Refer to Oil Pan, Oil Pan Gasket Removal and Installation .

Fig 2: Identifying Automatic Transaxle Input Speed Sensor Mounting Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Install the transaxle fluid drain plug using the plug remove/installer DW260-070.
Install the engine under cover. Refer to ENGINE UNDER COVERS REMOVAL AND INSTALLATION .

Fig 3: Identifying Plug Remove/Installer DW260-070
Courtesy of SUZUKI OF AMERICA CORP.
Lower the vehicle.
Connect the transaxle wiring harness and the PNP switch electrical connector.
Refill the transaxle fluid. Refer to Transaxle Fluid Level Checking Procedure .
Connect the negative battery cable.

Fig 4: Identifying PNP Switch Electrical Connector
Courtesy of SUZUKI OF AMERICA CORP.