A/C Discharge Hose-Compressor to Condenser Installation

Install new sealing washers at the compressor connecting block end and a new O-ring at the condenser connecting block end.
Position the hose into the vehicle, and install the nut at the condenser connecting block.
Tighten:

Tighten the discharge hose connecting block-to-condenser retaining nut to 16 N.m (12 lb-ft).

Fig 1: Identifying Condenser Connecting Block & Nut
Courtesy of SUZUKI OF AMERICA CORP.
Mate the hose connecting the connecting block to the compressor, and install the retaining nut.
Tighten:

Tighten the discharge hose connecting block-to-compressor retaining nut to 38 N.m (28 lb-ft).
Evacuate and recharge the A/C system. Refer to Discharging, Adding Oil, Evacuating and Charging Procedures for A/C System .
Connect the negative battery cable.

Fig 2: Identifying Compressor Hose Connecting Block & Nut
Courtesy of SUZUKI OF AMERICA CORP.