Code 1 - In-Car Sensor Error
This code will set if the output of the in-car sensor indicates a probable short circuit or an open in the sensor or the associated wiring harness or a malfunction of the ATC controller.
DIAGNOSTIC PROCEDURE
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| 1 |
Is there any sign of damage in the wiring or connector, or is the resistance outside the specified value at 20 - 25 °C (68 - 77 °F)? |
2,600 - 2,100 Ω | Go to Step 2 | Go to Step 3 |
| 2 | Repair the damaged wiring or the connector, or replace the in-car sensor as required. Is the repair complete? |
- | System OK | - |
| 3 |
Is the voltage equal to the value specified? |
> 4 V | Go to Step 7 | Go to Step 4 |
| 4 | Check the terminals on the in-car sensor connector. Is any problem found with the connector? |
- | Go to Step 5 | Go to Step 6 |
| 5 | Repair the connector terminals or replace the in-car sensor or ATC controller as required. Is the repair complete? |
- | System OK | - |
| 6 |
Does this display indicate the continuing presence of a code 1 condition? |
- | Go to Step 7 | System OK |
| 7 | Replace the ATC controller. Is the repair complete? |
- | System OK | - |