Clutch B/E Disassembly and Assembly
Tools Required:
DW260-140 Clutch B Stop Ring Remover/Installer
DW260-150 Clutch E Stop Ring Remover/Installer
- Remove the rear cover. Refer to Rear Cover Disassembly and Assembly .
- Remove the two sealing rings (clutch B/E).
- Take out input shaft with clutch B/E.
- Remove needle bearing and thrust washer.
- Remove shim.
- Take out the retaining snap ring.
- Take out the piston B.
- Remove disc set B.
- Take out the piston rings.
- Remove inner disc carrier E and needle roller thrust bearing.
- Take out the snap ring.
- Remove disc set E.
- Press down cup spring (clutch E) with cup spring press fixture.
- Remove the split stop ring.
- Remove the oil dam and cup spring.
- Pull the O-ring off the oil dam.
- Press down cup spring (clutch B) with cup spring press fixture.
- Remove the split stop ring.
- Remove the cup spring.
- Installation should follow the removal procedure in the reverse order.