LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2005 >> Verona EX >> Repair and Diagnosis >> Transmission >> Automatic Transmission >> Repair Instructions >> Control Valve Body Assembly Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Control Valve Body Assembly Installation

  1. Tilt the valve body.
  2. Install the output speed sensor mounting bolt.

    Tighten 

    Tighten the output speed sensor mounting bolt to 6 N.m (53 lb-in).

    Fig 1: Installing Output Speed Sensor Mounting Bolt
    G04095451Courtesy of SUZUKI OF AMERICA CORP.
  3. Install the control valve body and the bolts.

    Tighten 

    Tighten the valve body mounting bolts to 8 N.m (71 lb-in).

  4. Install the input speed sensor mounting bolt.

    Tighten 

    Tighten the input speed sensor mounting bolt to 8 N.m (71 lb-in).

  5. Install the oil pan and oil pan gasket. Refer to "OIL PAN AND OIL PAN GASKET INSTALLATION ".
    Fig 2: Installing Input Speed Sensor Mounting Bolt
    G04095452Courtesy of SUZUKI OF AMERICA CORP.
  6. Install the transaxle fluid drain plug using the plug remove/installer DW260-070.
  7. Install the engine under cover. Refer to "ENGINE UNDER COVERS INSTALLATION ".
    Fig 3: Installing Transaxle Fluid Drain Plug
    G04095453Courtesy of SUZUKI OF AMERICA CORP.
  8. Lower the vehicle.
  9. Connect the transaxle wiring harness and the PNP switch electrical connector.
  10. Install the air filter housing.
  11. Refill the transaxle fluid. Refer to "FLUID LEVEL SET AFTER SERVICE ".
  12. Connect the negative battery cable.
    Fig 4: Identifying PNP Switch Electrical Connector
    G04095454Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals