Assembly Procedure

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Bushing Shaft & KM-508-A

Courtesy of GENERAL MOTORS CORP.

Coat the control arm rear shaft with a multipurpose lubricant. Refer to Fluid and Lubricant Recommendations in General Information.
Press the rear bushing onto the shaft. The flat of the bushing must be on the top side, the same as the ball joint. Use the KM-508-A (1) to support the control arm. See Special Tools .

Fig 2: Bushing, Control Arm & KM-508-A

Courtesy of GENERAL MOTORS CORP.

Coat the outside of the front bushing and the inside of the lower control arm with a multipurpose lubricant. Refer to Fluid and Lubricant Recommendations in General Information.
Press the new bushing into the control arm from the back to the front, using the KM-508-A (1). See Special Tools .
Center the bushing.
Install the control arm. Refer to Control Arm Replacement .