LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Sensing and Diagnostic Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: SDM Electrical Connector
    GM1252017Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Sensing and Diagnostic Module Handling Caution in Cautions and Notices.
    CAUTION: Refer to SRS Caution in Cautions and Notices.
    CAUTION: If the vehicle interior is exposed to moisture and becomes soaked up to the level of the sensing and diagnostic module (SDM), the SDM and SDM harness connector must be replaced. The SDM could be activated when powered, which could cause airbag deployment and result in personal injury.
  1. Disable the supplemental inflatable restraints (SIR). Refer to Disabling the SIR System .
  2. Remove the floor console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages, and Console.
  3. Remove the connector position assurance lock, which is tethered to the SDM connector.
  4. Disconnect the SDM electrical connector.
  5. Remove the SDM mounting bolts.
  6. Remove the SDM.
scientia non olet · About LEMON Manuals