Installation Procedure
WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
- Clip the contact ring on the steering wheel, if necessary.
- Align the match marks on the steering wheel and the steering column shaft. Turn the signal-canceling cam on the wheel to the left.
- Install the retaining clip and the steering wheel nut.
Tighten: Tighten the steering wheel nut to 38 N.m (28 lb ft).
- Bend the tabs to secure the retaining clip.
- Install the SIR module. Refer to Disabling the SIR System in SIR.
- Connect the negative battery cable.
IMPORTANT:
In order to install the steering wheel correctly, match-mark the steering column shaft to the steering wheel.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.