Removal (Swift)
WARNING: This page is about a different variant/trim than selected.
- Release fuel pressure. See FUEL PRESSURE RELEASE . Disconnect battery cables. Remove battery, battery tray and hood (disconnect windshield washer hose from hood). Drain coolant and remove radiator hoses. DO NOT remove drain plug and radiator cap while engine and radiator are still hot. Remove air cleaner and air cleaner outlet hose.
- Disconnect the following cables:
- Accelerator cable from throttle body.
- A/T throttle pressure control cable from A/T.
- Clutch cable from transmission (M/T).
- Gear select cable from transmission (A/T).
- Disconnect following electric wires:
- Ignition coil assembly
- Ground wires from surge tank
- Engine oil pressure switch
- EVAP canister purge valve (if equipped)
- Engine coolant temp. sensor
- Fuel injectors
- Power steering pressure switch (if equipped)
- Oxygen sensor-1
- Back-up light switch (M/T)
- Transmission range switch (A/T)
- A/T vehicle speed sensor (A/T)
- Generator
- Starter
- Battery negative cable from transmission
- TP sensor
- IAC valve
- CMP sensor
- MAP sensor and then release wire harnesses from clamps.
- Disconnect the following hoses:
- Canister purge hose from EVAP canister purge valve
- Brake booster hose from intake manifold
- Radiator outlet hose from inlet pipe
- Heater inlet and outlet hose from heater unit
- Disconnect fuel feed and return hoses from fuel delivery pipe. Remove exhaust No. l pipe (if equipped) and exhaust pipe. Remove right and left engine under covers. Remove gear shift control shaft from transmission and remove extension rod (M/T).
- For A/T vehicle, disconnect A/T select cable from A/T. Drain engine and transmission oil. Disconnect drive shaft joints from differential gears of transmission or center bearing support. In this case, it is not necessary to disconnect drive shafts from steering knuckle.
- With hoses connected, detach A/C compressor and/or P/S pump with bracket from cylinder block, if equipped. Suspend removed compressor and/or pump at a place where no damage will be caused during removal and installation of engine with transmission. Disconnect P/S hose from P/S oil pump. (if equipped). Plug pipe, hose and pump port.
- Install lifting device. Remove rear mounting from body. (For M/T model). Remove rear torque rod (For A/T model). Remove engine left mounting from body. Remove engine right mounting from right mounting bracket and stiffener.
- Before removing engine with transmission from body, recheck to make sure all hoses, electric wires and cables are disconnected from engine and transmission. Lower engine with transmission from body.