Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Window Weatherstrip Run Channel Assembly (2 Of 2)

Courtesy of SUZUKI OF AMERICA CORP.

Align the notch in the window weatherstrip seal to the fixed window post and press the weatherstrip onto the window flange.
1. Press the weatherstrip run channel onto the door flange.
2. Ensure the channel is fully secured into the upper corners of the door frame.
Install the inner belt seal. Refer to INSTALLATION PROCEDURE .
Install the rear door trim panel. Refer REAR SIDE DOOR TRIM PANEL REPLACEMENT .

Fig 1: Identifying Rear Door Window Run Channel & Seal (2 Of 2)

Courtesy of SUZUKI OF AMERICA CORP.

Install the window run channel seal assembly.
1. Place the seal assembly into the door frame.
2. Place the seal assembly on the door header.
3. Install the seal to the door header flange, starting from the front corner.
  CAUTION: Refer to FASTENER NOTICE
Install the screw to the upper corner.
Tightening torque

Tighten the nuts to 6 N.m (53 lb in).
Install the bolts to the left and right sides.
Tightening torque

Tighten the nuts to 10 N.m (89 lb in).
Install the rear door window weatherstrip run channel assembly. Refer to INSTALLATION PROCEDURE .
Install the rear door window. Refer to INSTALLATION PROCEDURE .