Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Shoulder Belt Webbing Retainer & Fastener (2 Of 2)

Courtesy of SUZUKI OF AMERICA CORP.

NOTE: Apply GM P/N 12345382 (Canadian P/N 10953489), Permatex® 24200 or equivalent on all restraint fasteners prior to installation.

Position the shoulder belt retractor into the center pillar positioning unit with the locking tab in the body structure notch.
CAUTION: Refer to FASTENER NOTICE .
Install the retractor fastener.
Tightening torque

Tighten the fastener to 45 N.m (33 lb ft).
Snap the shoulder belt webbing retainer into the center pillar.
Install the lower garnish molding into the center pillar. Refer to CENTER PILLAR LOWER GARNISH MOLDING REPLACEMENT .

Fig 2: Identifying Seat Belt
Courtesy of SUZUKI OF AMERICA CORP.
Install the seat belt to the seat assembly.