LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2023 >> Outlander SE, AWD >> Repair and Diagnosis >> Steering >> Steering Control Systems >> Steering Control System (1 Of 2) >> Basic Inspection >> Additional Service When Replacing Power Steering Control Module Control Unit >> Work Procedure >> Work Procedure (After Replacing Power Steering Control Module)
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Work Procedure (After Replacing Power Steering Control Module)

  1. PERFORM PROGRAMMING 

    With M.U.T.-III SE

    Perform power steering control module programming according to the procedure of "Programming" in M.U.T.-III SE Operation Manual. Refer to M.U.T.-III SE Operation Manual.

    CAUTION: During programming, maintain the following conditions:
    • Ignition switch: ON
    • Electric load: OFF
    • Steering wheel: Not steering
    • 12V battery voltage: 8 V or more (Check the value displayed on the M.U.T.-III SE screen.)
    • Vehicle speed: 0 km/h (0 MPH)

    >>

    GO TO 2 

  2. PERFORM NECESSARY WORK 
    1. Perform configuration. Refer to DESCRIPTION .
    2. Perform steering torque sensor calibration. Refer to WORK PROCEDURE .
    3. Turn the steering wheel from full left stop to full right stop three or more times.
    4. Perform self-diagnosis for "EPS/DAST 3".
    5. Erase the memory of self-diagnosis results.

      >>

      End of work.

scientia non olet · About LEMON Manuals