LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2023 >> Outlander SE, AWD >> Repair and Diagnosis >> Steering >> Steering Control Systems >> Steering Control System (1 Of 2) >> Basic Inspection >> Steering Torque Sensor Calibration >> Work Procedure
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Work Procedure

  1. STEERING TORQUE SENSOR CALIBRATION 

    With M.U.T.-III SE

    1. Ignition switch ON.
    2. Select "EPS/DAST 3".
    3. Select "Special function".
    4. Select "Learning".
    5. Select and run "Torque sensor neutral position learning".
      CAUTION:
      • Make sure that the tires and the steering wheel are in the straight-ahead position.
      • Do not apply torque to the steering wheel while the learning process is executed.
    6. Ignition switch OFF to ON.
    7. Wait 5 seconds.
    8. Ignition switch OFF to ON.
    9. Erase self-diagnostic results for "EPS/DAST 3".
    10. Pull the parking brake switch.
      NOTE: Check the parking brake switch indicator is turn On.
    11. Ignition switch OFF.
    12. Get out of the vehicle and close all doors.
    13. Wait 65 seconds.
      NOTE:
      • Check the parking brake switch indicator turn OFF.
      • If the rear brake caliper is heated, wait an hour so that parking brake switch indicator does not turn OFF.
    14. Ignition switch ON.
    15. Perform self-diagnosis for "EPS/DAST 3".

      Is DTC C1608-46 or C160B-54 detected? 

      YES >>

      Ignition switch OFF once, and then repeat the procedure from the start.

      NO >>

      Work End

scientia non olet · About LEMON Manuals