Section 1 (Engine Mechanical - 3.8L)
WARNING: This page is about a different variant/trim than selected.
- General Description
- Engine Diagnosis
- Special Tools
- On-Vehicle Service
- Drive Belt (For Generator, Power Steering Oil Pump And Air Conditioning) Tension Check And Adjustment
- Valve Clearance Check And Adjustment
- Rocker Arm Piston Operation Check <Intake Side>
- Ignition Timing Check
- Curb Idle Speed Check
- Idle Mixture Check
- Compression Pressure Check
- Manifold Vacuum Check
- Lash Adjuster Check
- Engine Assembly
- Removal And Installation
- Notes
- Removal Service Points
- <<A>> Fuel High-Pressure Hose Disconnection
- <<B>> Exhaust Manifold (Right Bank) Removal
- <<C>> Radiator Removal
- <<D>> Power Steering Oil Pump Removal
- <<E>> Engine Hanger/Engine Oil Dipstick Assembly/Throttle Body Stay/Intake Manifold Plenum Stay (Rear) Removal
- <<F>> Transaxle Assembly Removal
- <<G>> A/C Compressor Assembly Removal
- <<H>> Engine Front Mounting Bracket Removal
- <<I>> Engine Assembly Removal
- Installation Service Points
- Removal And Installation
- Camshaft Oil Seal
- Camshaft And Valve Stem Seal
- Removal And Installation
- Notes
- <Left Bank>
- <Right Bank>
- Removal Service Points
- Installation Service Points
- >>A<< Camshaft Oil Seal Case Gasket/Camshaft Oil Seal Case/Oil Feeder Control Valve Housing Gasket/Oil Feeder Control Valve Housing Installation
- >>B<< Gasket/Oil Feeder Control Valve Pipe/Eye Bolt Installation
- >>C<<O-Ring/Engine Oil Control Valve Installation
- >>D<< Engine Oil Pressure Switch Installation
- >>E<< Valve Stem Seal Installation
- >>F<< Valve Spring Installation
- >>G<< Valve Spring Retainer Lock Installation
- >>H<< Rocker Arm And Shaft Assembly Installation
- >>I<< Camshaft Oil Seal Installation
- >>J<< Camshaft Sprocket Installation
- >>K<< Camshaft Position Sensor Support Installation
- Removal And Installation
- Oil Pan And Oil Screen
- Crankshaft Oil Seal
- Cylinder Head Gasket
- Timing Belt
- Specifications