LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 1996 >> B3000 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 172 (Engine Controls - System/Component Tests - EEC-IV (5.0L)) >> Computerized Engine Controls >> Powertrain Control Module (Pcm) >> Power Circuits
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Power Circuits

WARNING: This page is about a different car, the 1995 Ford Pickup, 1995 Ford Econoline, 1995 Ford Club Wagon, and 1995 Ford Bronco. However, it is still accessible from the selected car via links, so may be relevant.

Using a voltmeter, check for battery voltage between PCM terminal No. 1 (KAPWR) and ground. Also check for battery voltage at terminals No. 37 and 57 (VPWR). If battery voltage is not present, power is not being supplied from EEC power relay. See CIRCUIT TEST B in TESTS W/CODES - EEC-IV (5.0L) article.

PCM LOCATION

Application Location
Bronco & Pickup Behind Left Kick Panel
RWD Van Under Right Side Of Instrument Panel, Below Heater Blower Motor
Fig 1: Identifying PCM 60-Pin Connector Terminals
G90I09354