Work Procedure

SAVE VIN DATA (AV CONTROL UNIT)
CONSULT work support: Perform "SAVE VIN DATA" to save current VIN data.

>>

GO TO 2

.
SAVE "OPERATION LOG"
CONSULT Save Operation Log, according to the procedure of "Programming" in CONSULT Operation Manual.

NOTE: AV control unit part number is saved in "Operating Log" saved in CONSULT.

>>

GO TO 3

.
REPLACE AV CONTROL UNIT
Replace AV control unit. Refer to AV CONTROL UNIT : Removal and Installation .

>>

GO TO 4

.
CHECK "OPERATION LOG"
CONSULT Check "Operation Log" saved before replacing the AV control unit, according to the procedure of "Programming" in CONSULT Operation Manual.

NOTE: For the vehicle that the programming is to be performed, check if "Operation Log" of parts number is in Saved Data List.

Is there an applicable Operation Log in the Saved Data List?

YES>>

GO TO 5

.

NO>>

GO TO 6

.
PERFORM AV CONTROL UNIT PROGRAMMING
CONSULT Perform AV control unit programming, according to "Programming" of CONSULT Operation Manual. Refer to CONSULT Operation Manual.
CAUTION:
During programming, maintain the following conditions:
- Ignition switch: ON
- Electric load: OFF
- Brake pedal: Not depressed
- 12 V battery voltage: 12 - 13.5 V (Check the value displayed on the CONSULT screen.)
>>

GO TO 8

.
READ IN AV CONTROL UNIT PART NUMBER BY "EPC LINKED"
Obtain AV control unit part number by EPC (service parts catalog), according to the procedure of "EPC linked" in CONSULT Operation Manual. Refer to CONSULT Operation Manual.

CAUTION:
Be sue select "EPC linked".

NOTE: "EPC linked" allows an appropriate programming by obtaining ECU part number from EPC (service parts catalog) even when the part number cannot be obtained from the old ECU used before replacing with a new one.

>>

GO TO 7

.
PERFORM PROGRAMMING (EPC LINKED)
CONSULT Perform AV control unit programming according to the procedure of EPC linked in CONSULT Operation Manual. Refer to CONSULT Operation Manual.
CAUTION:
During programming, maintain the following conditions:
- Ignition switch: ON
- Electric load: OFF
- Brake pedal: Not depressed
- 12 V battery voltage: 12 - 13.5 V (Check the value displayed on the CONSULT screen.)
>>

GO TO 8

.
CONFIGURATION (AV CONTROL UNIT)
CONSULT Configuration: Perform configuration. Refer to Work Procedure .

>>

GO TO 9

.
WRITE VIN DATA (AV CONTROL UNIT)
CONSULT work support: Perform "WRITE VIN (SAVED DATA)" or "WRITE VIN (MANUAL INPUT)" to write VIN data.

>>

GO TO 10
CHECK NETWORK INITIAL SETTINGS
CONSULT Work Support: Select "Work Support" of "MULTI AV" and perform "Network initial settings".

>>

WORK END