Work Procedure

WRITING MODE SELECTION
CONSULT Configuration: Select "Re/programming, Configuration" of "MULTI AV".

When writing saved data>>

GO TO 2.

When writing manually>>

GO TO 3.
WRITING VEHICLE SPECIFICATION
CONSULT Configuration: Select "Configuration" or "After Replace ECU", and write the vehicle specification saved in CONSULT to display control unit.

CAUTION:
Do not perform any operation such as the navigation operation during configuration writing.

>>

GO TO 4.

WRITE VEHICLE SPECIFICATION

CONSULT Configuration: Select "Manual Configuration", and write the setting value as shown in the following table to display control unit according to the vehicle specification.

CAUTION:

Grasp vehicle specifications precisely. The control of ECU may not function normally if the specifications are misread.

NOTE:

The items shown in this list depend on vehicle specifications.
The config list may not be displayed depending on vehicle specifications. This is not a malfunction.
If selection items are not displayed on the CONSULT screen, touch "NEXT".

MANUAL SETTING ITEM		Detail
Items	Setting value	Detail
TELEMATICS	WITH	Models with telematics system
TELEMATICS	WITHOUT	Models without telematics system
AUDIO AMP TYPE	2ch	Models with BOSE audio system (13 speakers models)
AUDIO AMP TYPE	Bose Performance AMP	Models with BOSE audio system (17 speakers models)

GO TO 5.

PERFORM SELF-DIAGNOSIS
CONSULT Self Diagnostic Result: Perform self-diagnosis of CONSULT, and check whether or not DTC B1341-55 is detected. Is DTC B1341-55 detected?

YES>>

GO TO 3.

NO>>

GO TO 5.
OPERATION CHECK
Check that the operation of the display control unit and camera images (fixed guide lines and predictive course lines) are normal.

>>

GO TO 6

.
CHECK NETWORK INITIAL SETTINGS
CONSULT Work Support: Select "Work Support" of "MULTI AV" and perform "Network initial settings".

>>

WORK END