Work Procedure
- Always perform the front camera unit configuration after replacing the front camera unit.
- Always perform the camera aiming after removing and installing or replacing the front camera unit.
CAUTION:
The system does not operate normally unless the front camera unit configuration and the camera aiming adjustment are performed. Always perform them.
- FRONT CAMERA UNIT CONFIGURATION
- Perform the front camera unit configuration with CONSULT. Refer to Work Procedure .
>>
GO TO 2.
- CAMERA AIMING ADJUSTMENT
- Perform the camera aiming adjustment with CONSULT. Refer to Work Procedure .
>>
GO TO 3.
- PERFORM SELF-DIAGNOSIS
- Perform the self-diagnosis of front camera unit with CONSULT. Check if any DTC is detected.
Is any DTC detected?
YES>>
Perform the trouble diagnosis for the detected DTC. Refer to DTC Index .
NO>>
GO TO 4.
- ACTION TEST
-
- Perform the following system action test.
- LDW: Refer to Work Procedure .
- LDP: Refer to Work Procedure .
- Blind Spot Intervention: Refer to Work Procedure .
- TSR: Refer to Work Procedure .
- ProPILOT Assist: Refer to Work Procedure (7 inch information display) or Work Procedure (FULL TFT METER).
- Check that the each system operates normally.
- Perform the following system action test.
>>
WORK END
-