Work Procedure
- Perform action test to verify the customer's concern.
- Perform action test and check the system operation after system diagnosis.
Warning:
WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.
CAUTION:
- Fully understand the following items well before the road test;
- System description: Refer to System Description .
- Handling precaution: Refer to Precautions for Lane Departure Prevention .
- CHECK LDP SYSTEM SETTING
-
- Start the engine.
- Check that the LDP system setting can be enabled/disabled on the information display.
- Turn OFF the ignition switch and wait for 30 seconds or more.
- Check that the previous setting is saved when the engine starts again.
>>
GO TO 2.
-
- ACTION TEST FOR LDP
-
- Enable the setting of the LDP system on the information display.
- Turn LDP system display ON.
- Check the LDP operation according to the following table.7 inch Information Display
Condition Action Display on information display Steering vibration LDP OFF - OFF LDP ON Vehicle speed is less than approx. 60 km/h (37 MPH) - White OFF LDP system indicator: White. Dynamic driver assistance icon: White Vehicle speed is approx. 60 km/h (37 MPH) or more Vehicle closes to lane marker Turn signal is OFF or ON (Opposite to the deviate side) Yawing control is ON Yellow (Blink) ON LDP system indicator: Yellow (Blink) Dynamic driver assistance icon: White Turn signal is ON (Deviate side) - LDP system indicator: White. Dynamic driver assistance icon: White OFF Vehicle closes to lane marker with soft braking - Yawing control is ON Yellow (Blink) ON LDP system indicator: Yellow (Blink) Dynamic driver assistance icon: White FULL TFT METERCondition Action Display on information display Steering vibration LDP OFF - OFF LDP ON Vehicle speed is less than approx. 60 km/h (37 MPH) - LDP system indicator: White. Speaker icon : White OFF Vehicle speed is approx. 60 km/h (37 MPH) or more Vehicle closes to lane marker Turn signal is OFF or ON (Opposite to the deviate side) Yawing control is ON Yellow (Blink) ON LDP system indicator: Yellow (Blink) Speaker icon : White Turn signal is ON (Deviate side) - LDP system indicator: White. Speaker icon : White OFF Vehicle closes to lane marker with soft braking - Yawing control is ON Yellow (Blink) ON LDP system indicator: Yellow (Blink) Speaker icon : White NOTE:After the operating conditions of warning are satisfied, the warning continues until the vehicle speed reaches approximately 60 km/h (37 MPH). Refer to System Description .
>>
INSPECTION END
-