Work Procedure
WARNING: This page is about a different car, the 2020 Infiniti QX80. However, it is still accessible from the selected car via links, so may be relevant.
Always perform the lane camera unit configuration and adjust the camera aiming after removing and installing or replacing the lane camera unit.
CAUTION:
The system does not operate normally unless the camera aiming adjustment is performed. Always perform it.
- LANE CAMERA UNIT CONFIGURATION
Perform the lane camera unit configuration with CONSULT. Refer to Work Procedure .
GO TO 2.
- CAMERA AIMING ADJUSTMENT
Perform the camera aiming adjustment with CONSULT. Refer to Work Procedure .
GO TO 3.
- PERFORM SELF-DIAGNOSIS
Perform the self-diagnosis of lane camera unit with CONSULT. Check if any DTC is detected.
Is any DTC detected?
YES
Perform the trouble diagnosis for the detected DTC. Refer to DTC Index .
NO
GO TO 4.
- CHECK FEB SYSTEM SETTING
- Start the engine.
- Check that the FEB system setting can be enabled/disabled on the combination meter.
WORK END.